Hi Fred, I don't think that there is a way to use find_ncs.resolve....however instead yes you can input find_ncs.ncs_spec, a file that should have been written at the same time as find_ncs.resolve. This file contains all the ncs information and should be recognized by the autobuild gui. I hope that helps! All the best, Tom T ________________________________________ From: [email protected] [[email protected]] on behalf of Fred. Vellieux [[email protected]] Sent: Tuesday, August 07, 2012 5:33 AM To: [email protected] Subject: [phenixbb] use of the file find_ncs.resolve Hi all, I do not understand how the file "find_ncs.resolve" has to be fed into the "resolve" part of Phenix. Can it be used in the GUI for an autobuild procedure? Can anyone help on this? Ta very much in advance, F. Vellieux -- F.M.D. Vellieux (B.Sc., Ph.D., hdr) IBS / ELMA 41 rue Jules Horowitz 38027 Grenoble Cedex 01 France Tel: +33 438789605 Fax: +33 438785494 _______________________________________________ phenixbb mailing list [email protected] http://phenix-online.org/mailman/listinfo/phenixbb