HI all, I want to use phenix.autobuild to calculate SA-OMIT map. BY default, it will be seperated into 16 regions. How could I set a different number of omit regions? Is there any difference of the final omit map by setting different regions? The phenix.autobuild manual says: If you are calculating an omit map, then use nproc=5 * number of omit regions (i.e., up to 100 or more, depending on how many processors you have). Does the * mean to use regions number to multiply 5? If my computer have 16 processors and I want to use 48 regions, so my command should be this: nproc=240. Am I right? Thank you! The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.