Hello, I am refining a high-resolution X-ray structure and I would like to gradually increase the resolution from 1.5 to 1.0A, as I used to do in shelxl. I know the STIR command is the way to do this, but I cannot figure out the syntax to use. Currently I am using the following commands: high_resolution = 1.0 low_resolution = None stir = 1.5 When I run phenix.refine (2008_02_08_1610) it echos a line that says "STIR 1.5" before the first macrocycle, but at each stage I see "(resolution: 1.00 - 21.77)." Obviously I am not using the STIR command correctly. Any advice would be greatly appreciated. Thanks in advance. Nick Silvaggi Department of Physiology and Biophysics Boston University School of Medicine 715 Albany St. R-702 Boston, MA 02118