Note that original request was sent to both phenix and ccp4 bulletin boards. And I think most reasonable people have agreed in the past that advertising phenix on ccp4bb is OK (at the least on the freedom of speech grounds :) So I guess the reverse must also be true Cheers, Ed On Mon, 2011-02-14 at 13:02 +0100, Christian Roth wrote:
I dont wanna advertise too much non phenix programs, but in principle chainsaw(CCP4 supported) should do what you want and trim your model to C- beta.
Regards Christian
Am Samstag 12 Februar 2011 00:03:32 schrieb crystallogrphy:
Hi, I am refining a low resolution data (4.7A). I want to cut off all side chains from my model because they cannot be seen from the density. Phenix pdbtools can only keep the backbone, but cannot keep the Cbeta atom. What program I can use to cut off all the side chain, but keep the Cbeta atoms?
Thanks!
_______________________________________________ phenixbb mailing list [email protected] http://phenix-online.org/mailman/listinfo/phenixbb
-- "I'd jump in myself, if I weren't so good at whistling." Julian, King of Lemurs